Newest Questions

0 votes
0 answers
7 views

Central air blower fan randomly starts and stops

Blower fan will randomly start for a few minutes, then stop and start again. Eventually it stops for hours or will run normally when the compressor starts for cooling. What should I be checking?
Michael's user avatar
0 votes
1 answer
28 views

Fridge handle shaking slightly

My fridge (electrolux , model EI32AR80QSC) handle is shaking very slightly (it's not tight). As much as a try tightening that tiny screw, it won't help at all. Twice already I had a handyman at home (...
Samnews's user avatar
  • 211
0 votes
0 answers
42 views

How much can my steel column support?

How many kilograms of load can a steel column 48.3 mm diameter with a wall thickness of 4 mm and 1.2 metres long support?
Metalpods's user avatar
0 votes
0 answers
12 views

Replacement condenser motor for Carrier HVAC unit part HC38GR224 [closed]

I have been trying to find a replacement for this part and it has been back ordered for month as per my technician. Could you help me with a suitable replacement part. I will appreciate your help. ...
Setu Jain's user avatar
-1 votes
1 answer
37 views

Please help me identify my rough-in plumbing [closed]

I am hoping to plan out finishing my basement. Please help me Identify my rough in plumbing. #1 and #3 are 2" pipes. #4 is a 3.25" pipe. #2 is about 4.5" and sealed. #5 is about 6.5&...
Chris Keyes's user avatar
1 vote
1 answer
50 views

Interior Door Latch Seems Too Long

We're updating a house built in 1974. I purchased Defiant Hartford door knobs as replacements. When I went to install the first Defiant latch it bottoms out in the bore (opening) and will not fully ...
Gene Henson's user avatar
1 vote
2 answers
42 views

Kitchen faucet hose replacement help

My kitchen faucet hose has sprung a leak. I am trying to change it but can't figure out the make or model and don't quite know how to undo the hose from under the sink. The faucet was purchased from ...
shikarishambu's user avatar
0 votes
0 answers
35 views

Skillsaw model3400 table saw kicks off

I have a model 3400 skil table saw. When its turned on it starts up then makes a loud noise and then kicks off. Checked for obstructions but the blade will turn by hand. Its been sitting in the ...
Chris's user avatar
  • 1
0 votes
1 answer
30 views

What type of paint for exposed brown paper under drywall on bathroom ceiling?

The bathroom ceiling has drywall with areas where the brown paper layer is exposed. What is the correct type of paint or primer to use over it? I don't want to re-mud the ceiling, just repaint it. The ...
Bluesail20's user avatar
0 votes
1 answer
56 views

Installing dishwasher in location not near sink and without existing drain

I have a small old kitchen with metal cabinets from the 1950's, currently with no dishwasher, and very limited options for placement of one. Putting one beside or close to the sink/garbage disposal ...
User41943's user avatar
  • 185
0 votes
1 answer
35 views

What are the materials surrounding this shower elbow drop?

I am changing the shower arm, and found this within the hole they made in the cement tile of the shower. From back to front: Green circle. Is that some old tape? There is some of that old debris more ...
elektrei's user avatar
0 votes
0 answers
36 views

Gfci has power but won’t test or work [closed]

Gfci outlet stopped working. Wouldn’t test. Replaced gfci. Still won’t test or work but green light on and power present. What do I do next to get power to my outlets?
Ron's user avatar
  • 1
0 votes
3 answers
96 views

Feeding Shed Subpanel with Two separate Cables

I have a detached shed that I want to run power to for light load lights and outlets. I have a lot of direct bury 10 AWG 2conductor with ground I would like to use instead of buying larger cable, 3/...
David Lee's user avatar
0 votes
0 answers
9 views

Where can I find a Sauder Glass Door Bookcase Slider Bar? [closed]

I purchased 2 of these Sauder bookcases (Barrister style) with glass doors back in 2006 or 2007. From much use, several of these slider bars broke. The door is useless without them.I have searched but ...
Pampered Products's user avatar
0 votes
1 answer
26 views

Wood filler for screw holes into faux wood

I have french doors that have screw holes into the trim around the window. It’s not very pleasing to look at. What is the best product to address this. The trim is faux wood with wood grain finish and ...
DIYNoob's user avatar
  • 21

15 30 50 per page
1
3 4
5
6 7
6079